Silhouette Kraft Blade - 3mm - Pack of 2 units

More information about the 3 mm Kraft Blade for Cameo 4

• The blade is automatically detected by the Silhouette Studio software. You will not need to select it.
• Stainless steel blade, suitable for cutting materials up to 3 mm thick.
• Manual adjustment of the cutting depth by twisting the lower part until the red line points to the desired value.
• It may be recommended to use a strong-tack cutting mat when using the 3 mm Kraft Blade with certain materials.
• It is convenient to cut heavier media gradually (using a series of passes), and manually adjust each material’s settings separately. This will prevent the blade from digging into the mat which could mess up the entire cut.
• Presented in 2-unit blister packs.

INSTRUCTIONS FOR USE

• Adjust the length of the blade according to the material to be cut.
• Insert the blade in the right tool holder (Tool Holder 2).
• Lock the tool by pushing the lock lever all the way in.
• When working with a new type of material, you should always run some tests to find which settings will give you better results.
• Once the design is ready in Silhouette Studio, click on “SEND” (top-right corner).
• Select the settings for the material you will be cutting and send the design to the plotter.